(Settings and data are saved in the mapped folder) Acknowledge that all the data in the container will be lost.Select the Unifi Controller container again.Stop the Unifi Controller container by flipping the on-off switch.Tip: subscribe to my email list in the sidebar to receive a notification when a new version is available! There is no auto-update feature either, so when a new version comes out, you will need to download a new version of the Docker Unifi Image. You can’t just download the latest version and run the installer inside the Docker container. Updating the Unifi Controller on the Synology is a little bit different compared to a Linux/Windows/Rasberry Pi installation. The Unifi Controller will start automatically after the reboot. If this controller is still not accessible then it might be necessary to restart your Synology NAS. You should now be able to access the Unifi Controller. Select Ports > Custom and again Custom (button).Click on Edit Rules to open the ports for the Unifi Controller. Below that you will find the Firewall Profile. Here you will see the Enable Firewall is turned on. You don’t need to turn the firewall off, you only need to open some ports to allow traffic to the Unifi Controller. This will prevent you from accessing and using the Unifi Controller. Configure your Synology Firewallīy default, the Synology firewall is turned on. So if you can open your NAS on then you can find the Unifi Controller on. The Unifi Controller will now start and is accessible on your Synology address on port 8443. Scroll all the way down and change the following values:.This way we can reach the Unifi Controller on the same IP Address as our Synology NAS. In the column, Mount Path enter /unifi Network SettingsĬlick on the network tab and select Use the same network as Docker Host. ![]() ![]() Next, we need to map the newly created folder. We need to map the file storage of the Docker to the disk of Synology. This way the Unifi Controller will be restarted when your Synology turns is rebooted (after an update for example) Set Disk VolumeĬlick on the tab Volume. This is really recommended if you are running more applications on your NAS.
0 Comments
Leave a Reply. |